Estimation of Hydraulic Parameters from Vertical Electrical Resistivity Sounding

Authors

  • Blessing I. Etete Department of Physics, College of Science and Technology, Covenant University, Ota
  • Funmilola R. Noiki Department of Physics, College of Science and Technology, Covenant University, Ota
  • Ahzegbobor P. Aizebeokhai Department of Physics, College of Science and Technology, Covenant University, Ota

DOI:

https://doi.org/10.26713/jims.v9i2.732

Keywords:

Estimation, Hydraulic parameters

Abstract

This study presents the assessment of the groundwater potential in Iyesi, Ota, southwestern Nigeria. Thirty (30) vertical electrical soundings (VESs) were conducted using Schlumberger array with a maximum half-current  electrode spacing \((AB/2)\) of 420 m. The apparent resistivity data observed were interpreted first by  partial curve matching and then by computer iteration technique using WinResist program. Eight  eoelectric layers were denoted as top soil (sandy clay), lateritic clay, silty clay, silty sand,  mudstone, medium grain sand, coarse sand and clay mud were delineated. The sixth (medium grain sand)  and seventh (coarse sand) layers delineated form the aquifer unit with the overlying mudstone (fifth layer)  serving as the confining bed. The geoelectrical and hydrogeological characteristics of the delineated aquifer  in the study area was evaluated. The study shows that the aquifer is highly productive and consequently a good groundwater potential. The litho-facies of the aquifer units are well sorted and graded; this accounts  for the observed decrease in the model resistivity with depth and thus, increasing porosity with depth in the aquifer unit.

Downloads

Download data is not yet available.

References

G. Archie, The electrical resistivity log as an aid in determining some reservoir characteristics, Petroleum transactions of the American Institute of Mineralogical and Engineers 146 (1942), 54 – 62.

G. Archie, Introduction to petrophysics of reservoir rocks, American Association of Petroleum Geologists Bulletin s (1950), 943 – 961.

J.J. Breusse, Modern geophysical methods for subsurface water exploration, Geophysics 28 (1963), 633 – 657.

D.C. Carmen, Fluid flow through a granular bed, Transaction Institute of Chemical Engineering 15 (1937), 150 – 157.

D.C. Carmen, Flow of Gases through Porous Media, Academic Press, New York (1956), 182 p.

European Association of Exploration Geophysicists, Compagnie Generale de Geophysique, Master curves for electrical sounding, 2nd revised edition (1963), https://books.google.co.in/books/

about/Master_Curves_for_Electrical_Sounding.html?id=g1BmPAAACAAJ&redir_esc=y.

M.B. Dobrin, Introduction to Geophysical Prospecting, 2nd edition, McGrow-Hill, New York (1960), 446 p.

R.A. Freeze and J.A. Cherry, Groundwater, Prentice Hall Inc., Englewood Cliffs, New Jersey (1979), 7 p.

A. Ginzburg, Resistivity surveying, Geophysical Surveys 1 (1974), 325 – 355.

J. Kozeny, Ueber kapillare leitung des wassers im boden, Sitzungsberichte Akademie der Wissenschaften Wien 136 (1927), 271 – 306.

J. Kozeny, Hydraulics, Springer, Vienna (1953), 546 – 549.

P.G. Nutting, Physical analysis of oil sands, American Association of Petroleum Geologist Bulletin 14 (1930), 1337 – 1349.

Downloads

Published

2017-08-30
CITATION

How to Cite

Etete, B. I., Noiki, F. R., & Aizebeokhai, A. P. (2017). Estimation of Hydraulic Parameters from Vertical Electrical Resistivity Sounding. Journal of Informatics and Mathematical Sciences, 9(2), 285–296. https://doi.org/10.26713/jims.v9i2.732

Issue

Section

Research Articles